|
INSTRUCTIONS
FOR USE
PROPER INFLATION IS NECESSARY TO USE THIS PRODUCT INFLATION
INFLATION
Inner Grid:
The inner grid should be inflated orally with about two large
breaths of air for an average person. Do not use more air, two
breaths is all that is needed. Close the valve. Bunch up the SSR
and move the contained air around to separate both layers of
plastic. The SSR cannot be made to lie flat unless the layers
are separated. The SSR should be about the size of a soccer ball
when bunched up.
Outer Grid:
Inflate the outer ring orally until it is firm. Close the valve.
Place each SSR single layer in direct sunlight on a flat
non-abrasive surface until the packing lines relax. This should
take from 30 minutes to 3 hours depending on the intensity of
the sun. If the SSR does not lie flat after the packing lines
are relaxed, examine the SSR for areas not separated. If the SSR
still does not lie flat measure the diameter. A properly
inflated SSR is 59 inches or 149.86cm
in
diameter. If the SSR is smaller use the deflation tube provided
to let air out of the inner grid until it lies flat. Excessive
air in the grid section, deep packing lines and failure to
separate both layers of plastic will all cause the outer edge to
curl and distort.
HOW TO USE
THE SOLAR SUN RINGS
HEATING:
Once the Solar Sun Rings are inflated, cover up to 70% to 80% of
the surface of your pool with Solar Sun Rings by placing the
blue colored side on the water. You should not cover more than
70% of the surface on deep pools and not more than 80% on
shallow pools. For the best solar effect, keep the upper surface
of the Solar Sun Rings clean and clear.
COOLING: Turn the Solar Sun Rings over so the
blue side is up. The Solar Sun Rings do not heat water
efficiently when upside down.
WATER AND CHEMICAL SAVING: Neither water nor
chemicals can evaporate through the two layers of heavyweight
vinyl. You will save on water and chemicals about equal to the
actual percentage of water covered.
CARE OF
SOLAR SUN RINGS
CARE:Once
inflated proper care of this product will greatly extend its
useful life. Pool decking is designed to be abrasive to prevent
slips and falls. Do not walk on Solar Sun Rings or drag Solar
Sun Rings on this abrasive surface. When Solar Sun Rings are not
on the pool water do not stack them in direct sunlight,
excessive internal temperatures will develop and melt the vinyl
films.
Solar Sun Rings are passive pool heating devices and should not
be used as pool toys.
WARRANTY
WARRANTY:
Solar Sun Rings are warranted to be free of manufacturing
defects for two years. Warranty is limited to materials and
workmanship. Solar Sun Rings will not warranty products for
damage or suitability.
|
How Do Solar Sun Rings
Work?
At
night the contained air acts as an insulating blanket to retain
heat gained during daylight. Solar Sun Rings are equipped with
six magnets to improve clarity and decrease hardness of the
water in your pool. The magnets are positioned to facilitate
rafting. The strength of the magnets will permit single position
removal but will easily separate to prevent entrapment in
accidental falls.
Solar
Sun Rings were designed to be compatible with automatic pool
cleaners. In the event the suction hose catches on a ring, the
ring will separate from the raft to allow the pool cleaner to
continue.
Neither
water nor pool chemicals can evaporate through the Solar Sun
Rings two layers of heavyweight vinyl. You will save water and
chemicals about equal to the percentage of the surface of you
temperature, Solar Sun Rings may be turned over to conserve
water pool covered. Once the water in your pool has reached
adequate by limiting evaporation without significantly heating
the water.
How Many Solar Sun Rings Do I Need?
We
recommend enough Solar Sun Rings be purchased to cover 70% to
80% of your pools surface, ignoring the small triangles between
the rings.
10 x 15ft pool
recommends 7 pads
18ft x 33ft Pool
recommends 12 pads
Are Solar Sun Rings Compatible
With My Pool?
Solar
Sun Rings may be used on all chlorine or salt water system
pools, whether in ground or above ground.
How Do I Clean My Solar Sun Rings?
After
removal from the swimming pool Solar Sun Rings can be easily
cleaned with a sponge and mild detergent solution.
Solar Sun Rings Help
Your Pool Stay Clean
Your
pool requires some direct sunlight and open water to stay
healthy. The open water around the raft of Solar Sun Rings and
the triangle caused by the convergence of three Solar Sun Rings
is by design. These open areas allow your pool to receive some
direct sunlight. This sunlight will greatly reduce the incidence
of mustard algae.

|