|
Permanent
Pool Coving is a way to seal the space between the pool
wall and the liner.
Pool
Coving is:
- Flexible
and Lightweight
- Extends
Pool Life
- Easy
To Install
- Prevents
Washout and Corrosion
- Protects
Liners
- Will
Not Move Like Sand
Coving is an
Integral part of every pool system, whether with sand, (not
recommended) Or our neutral poly foam permanent cove.
Protect yourself from liner blow out.
Permanent
Pool Coving is a 3 inch by 4 inch preformed foam strip and is
safe for use with all pool liners. Lightweight and easy to
handle, Permanent Pool Coving comes in 48 inch long sections
that bend easily without breaking and works with all pool
brands. The plastic backing strip locks each section of
cove into the bottom rail, allowing it to move as the pool
wall expands and contracts. Unlike sand or dirt, Permanent
Pool Coving can not be washed out and will not hold moisture
against metal components. This feature reduces corrosion and
may add years of life to a pool and its components. Because
Permanent Pool Coving is made from a high density foam, it
will not change shape or indent, making pool cleaning easier
It Is recommended by the
manufacturer to purchase Pool Cove and Arthur's Comfy Bottom
Together
Arthur's
Comfort Bottom Pad
"Give
Your Pool A Comfy Bottom"
|
Installing Over
Straps
|
Comfy Bottom Going
Down in Strips
|
 |
Comfy Bottom
Installed Completely (Over Perma Cove)
|
|
|
Arthur's
Comfy Bottom:
- Is
Easy To Install
- Extends
Liner Life
- Insulates
Pool to Prevent Heat Loss
- Keeps
a Smooth "Comfy" Bottom for Easier Cleaning
- High
Density Lowe Compression and stays in place
Arthur's Comfy Bottom Pool Pad Will
Protect your liner for years. Made from a special high density
polyethylene foam, Arthur's Comfy Bottom Pool Pad acts
as a barrier to keep water away from metal
components, reducing rust and corrosion. In addition, by
adding a layer of protection between your pool liner and the
ground you had puncture protection and heat retention.
Arthur's Comfy Bottom
Pool Pad is easy to install. First, roll out sections of
pad and cut them one foot longer than the (biggest if oval)
dimension of the pool. Next, seam enough 4 ft. wide sections
together with tape to cover the (smaller if oval) dimension of
the pool. Trim off excess pad material after pool has been
filled.
|
