| 1. Take a pool water sample to
an Authorized POOLIDE Dealer for a full analysis. |
2. Balance the water per the
dealer's recommendations. If metals are detected, add
POOLIFE Metal Control per
label directions. |
| 3. Thoroughly brush and vacuum
the pool. |
| 4. Shock the water with POOLIFE
TurboShock or POOLIFE Rapid Shock per label directions for
Winterizing. |
| 5. Add a winterizing dose of
your preferred POOLIFE Algaecide - follow label
directions. |
| 6. Run the filter for 24 - 48
hours. Thoroughly vacuum and remove any debris. |
7. If there is a chlorine
feeder connected to the pool, make sure that there is no
remaining chemical in the feeder.
Clean and flush the feeder
per manufacturer's directions or run filter until all
remaining chemical has been
dissolved. |
| 8. Clean the filter with
the appropriate POOLIFE Filter Cleaner per label directions. |
9. Follow pool
manufacturer's directions on draining the pool so that the
water level is below the skimmers, and
inlet lines. |
| 10. Winterize all equipment
following the manufacturer's directions. |
11. Cover pool with
properly fitting pool cover. Cover should be resistant to
water, weather and pool chemicals.
Seal the edge of
the cover to prevent wind from getting under it. This
will save you clean-up time when you
re-open your pool
by keeping out unwanted debris. (If you secure the cover
with water bags, fill them only
halfway to allow
for expansion if they freeze.) |