In-Ground Pool Kits

Do It Yourself In-Ground Pool Kits are a great way to get an in ground pool in your backyard for a fraction of the price. If you are willing to do a little labor you could easily have your own in -ground pool for under $10,000. And these pools are not hard  to install, once you dig the hole.

In-Ground Pool Kits
Rectangle Radius Rectangle Oval
info info info
Grecian Roman Lazy L
info info info
Grecian Lazy L  Lagoon Keyhole
info info info
True L Kidney Mountain Lake
info info info
          In the world of swimming pools, most are users are separated by the terms “In-ground Pools”  and “Above Ground Pools”. What usually separates these terms is tens of thousand of dollars. The typical above ground pool can cost between one and four thousand dollars. The typical in-ground pools can cost twenty to forty thousand dollars or more. But there is one more option. In-ground pool kits. These pools provide the exact same experience of an gunnite pool at a fraction of the cost. These are in-ground pool kits and require customer installation. With easy instructions and a few helpers you can save yourself easily twenty thousand dollars by doing it yourself.  Before installing one of these pools please check with your county and city for the proper permit and ordinances and always before excavating check with your local utility to make sure you won’t hit any under ground utility lines. In-ground Pool Kits Installation (Steps in green are usually best subcontracted; purple is something you can do yourself)
  • Select your site and stake it out. Set your elevation so that the top of the pool will be 6 to 12 above the existing ground at the highest part of your concrete apron. (Don’t worry; it will all look flat when you’re finished.)
  • Dig The Hole. This is where Subcontractor#1 usually comes in. It will probably help if you can find one who has dug a pool before. In most parts of the country this will cost $300 – $600 and should take 6-8 hours with an experienced operator. Your local backhoe dealership should be able to recommend several experienced excavators. (1 Day)
  • Assemble the walls. They go together easily and sit on a ledge that is over dug around the pool. You’ll level them with a level or transit that sits on a tripod. Attach the coping around the top with the self tapping screws included. The coping has a receptor slot that holds the liner in. And will also act as a form for pouring the concrete apron. (1 Day)
  • Pour the footings around the outside walls. This secures everything in place. 8 to 10 inches thick and 2’ wide. No more adjusting the walls after this is poured. 6-8 yards of concrete. (½ Day)
  • Plumb the Pool. We’ll provide the plans and all the pool equipment. You provide the 1 ½” Schedule 40 PVC pipe and fittings. This PVC cuts with a hacksaw, glues in seconds and can be plumbed successfully by a novas in a couple hours. (1 Day)
  • Put in the bottom. Now is when you’ll want Subcontractor #2 to step in. Call a local concrete finisher and sub out the mixing and installation of the sand & portland bottom (or Pool Krete). Neither of these are designed to hold up the weight of the water, but will separate the dirt from the liner and give the liner a good smooth uniform fit. (1 Day)
  • Hang the liner and cut in the face plates. This is much easier with 2 to 3 people and takes about 2 hours to hang. The liner snaps in the coping and fits the dimensions of the pool. A wet-dry shop vacuum is used to suck the air out from behind the liner, which draws it snugly into place. You will now be ready to start adding the water. As the water is filling you will put on the faceplates. (½ Day)
  • Back fill the pool. Call that backhoe operator again to backfill or smooth out all the dirt around the pool. This should get it ready for the concrete finishers. (Cost should be about half what it was to dig the pool.) (½ Day)
  • Finish the Apron, (Many Options) Call that concrete finisher back and have him finish the concrete around the pool. A light to medium broom finish works the best and should slope away from the pool ¼ inch per foot. (1 Day)
  • Clean Up. Clean it using the manual vacuum and adjust the chemicals.


Comments are closed.